Know more on how Nu-Wood products assist builders to increase their bottom line, through labor savings and more productivity, all while giving their customers the look, quality and durability that they demand. Nu-Wood products assist builders to increase their bottom line, through labor savings and more productivity, all while giving their customers the look, quality and durability that they demand.
Made from an advanced process of molding polyurethane, we can replicate the look and feel of wood while integrating the advantages of polyurethane products - namely it will never chip, peel or crack, nor is it affected by the weather or insects. In most cases, our products are less expensive than a comparable millwork product made from natural wood.
Made from an advanced process of molding polyurethane, we can replicate the look and feel of wood while integrating the advantages of polyurethane products - namely it will never chip, peel or crack, nor is it affected by the weather or insects. In most cases, our products are less expensive than a comparable millwork product made from natural wood.
Services
Nu-Wood is a specially formulated polyurethane polymer that is molded to precisely replicate common wooden millwork and masonry products. Our products have the fine details you find in natural materials - the grain of specific wood species, the sand in mortar, the feel of trim board - minus the complications and expense of installing and maintaining them.
Nu-Wood has a two-coat factory finish on all parts. The first coat is chemically bonded to the urethane followed by a second coat of an exterior grade finish. This results in an elegant finish, which offers several years of maintenance free beauty. Since urethane doesn't absorb moisture, the finish is not subject to splitting, cracking or peeling such as wood millwork would be.
Unbox the column wrap. DO NOT disassemble the one non-glued side of the column from the three other sides until AFTER step #2. You should however remove the trim pieces from inside the column wrap. Measure the vertical space in which the column wrap will be mounted. Cut the new unboxed column wrap to 1/8" - 1/4 " shorter than the available space using a saw of your choosing.
TOOLS NEEDED Circular Saw, Jig Saw, Table Saw, Router, Screw Gun, Caulking Gun, Accent Bond, Mortar Seal, Tape measure, Level and Chalk Line or Tape Measure. ORIENTATION Make sure to have the panels orientated the correct way - the screw flange is along the top edge of the panel. STAGGER PANEL & CORNER Working left to right you may need to complete wall with a panel that has been cut to fill the void.
A non-corrosive countersunk fastener should be placed in accordance with this diagram. The circles represent countersunk screws or you can toe-screw at the x's. Fasteners should be placed at the top and bottom, then evenly spaced over the length of the shutter as shown. All mechanical fasteners are recommended as screws and should be countersunk and filled with caulk or other fill material and touch up painted.
Reviews
Be the first to review Jasper/Nu-Wood.
Write a Review